Your software release may not support all the features documented in this module. This chapter contains information about, and instructions for configuring IPv4 addresses on interfaces that are part of a networking device.Īll further references to IPv4 addresses in this document use only IP in the text, not IPv4. Example Maximizing the Number of Available IP Subnets by Allowing the Use of IP Subnet Zero.Example Using IP addresses with 31-Bit Prefixes on Point-to-Point WAN Interfaces to Limit Number of IP Addresses Required.Example Using IP Unnumbered Interfaces on Point-to-Point WAN Interfaces to Limit Number of IP Addresses Required.Example Increasing the Number of IP Hosts that are Supported on a Network by Using Secondary IP Addresses.Example Establishing IP Connectivity to a Network by Assigning an IP Address to an Interface.Configuration Examples for IP Addresses.Using IP addresses with 31-Bit Prefixes on Point-to-Point WAN Interfaces to Limit Number of IP Addresses Required.Using IP Unnumbered Interfaces on Point-to-Point WAN Interfaces to Limit Number of IP Addresses Required.Specifying the Format in Which Netmasks Appear for an Individual Line.Specifying the Format in Which Netmasks Appear for the Current Session.Maximizing the Number of Available IP Subnets by Allowing the Use of IP Subnet Zero.Increasing the Number of IP Hosts that Are Supported on a Network by Using Secondary IP Addresses.Establishing IP Connectivity to a Network by Assigning an IP Address to an Interface.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |